Hörman garagepoort aansturen

[MDAR]

UAP1 HCP Hormann promatic 4 garage door automation

@yvesfouquet4 As per the Dutch section reply Using an VMB6PBN, with a strict change to the configuration. Where the LED outputs are used as 0V triggers. NOTE WHERE THE 0V for the pulses is connected on the VMB6PBN This is done by Setting them to Monitoring Mode and attaching 0104 actions between the LED outputs and the Velbus buttons that you want to control them. (I have been doing this with Velux KLF200 controllers for years, and ASKING for a Velbus IO device for the same time, for exac…

---

Or, using an VMB6PBN

With the configuration as “monitoring” LED feedback
With button actions 0104
The VMB6PBN LED feedback follows the state of the button being pressed

Button Inputs of VMB6PBN show state of door interface

Or with a new VMB6PB-20
(ideally with the new firmware that has been discussed)

Traditionally like this